|
||||||
|
||||||
| D2CAD | What's New | Manual | History | Download |
| Let's make a network. |
|---|
| 1) How to make it output correctly |
| 2) A network and a pin |
| 3) The rule when attaching a signal name |
A network and a pin
| The conditions which a network generates from a pin are only the points of the outside of a pin. That which exists in the middle of a pin does not become a network even if it connects at a junction. By a diagram, the network of DS3 is not connected to six pins of U3. DS1 is connected to 2 of U3, and DS0 is connected to 5 of U3, respectively. |
| Schematic Editor D2CAD |
- Copyright © 1996-2024 YAN - support@yansoft.com
|
| This page is translated with translation software from Japanese. |
